well here it is. This took around 2 months to do. It has a "full" interior scaled to minifig trophies (1 stud= 1 meter). it also has retracting landing gear and retracting hard-points. The heat vents are movable and there is a SLF bay which can fit any of the 3 fighters that I've built from Elite. Lastly I tried my best to go for accuracy in this build, going as far as using Autocad to block out the interior space and other angles.
Instructions were attempted but I accidentally scrambled them due to forgetting to lock my pages. since there were over 1500 pages (that took me the bulk of the MONTH to do) I decided not to remake them.
Interior space was made according to this Autocad drawing I did.
Its here: i.imgur.com/Ff4Cs4x.png
the blue print is from here: www.elite-dangerous-blog.co.uk/
On this side of the Hab deck we have (from left to right) the living room, the kitchen, the fuel scoop, 2 limpets, empty size 1 and size 2 bulkheads, and the shield generator.
On this side of the Hab deck we have (from top to bottom) shield cell banks, a cargo hold that holds 32 cargo canisters, the bedroom with 4 beds, a TV and bathroom, and part of the fuel tank(the rest of the fuel would be contained in the large flat expanse of the top hull).
the cockpit has 3 seats and controls for the crew. however since a minifig trophy cant sit they wont fit into the chairs
The (from left to right) FSD and Power plant. I put them there after realizing that I could fit them in front of the thrusters which are not that long inside.
These heat vents have the FSD and Power plant behind them. that is why they arn't used as rear thrusters. there is a person to scale (the nanofig is 1.8 studs tall including the "stand")
these flaps are movable
The cannons are retractable and can be replaced with different kinds
however the middle cannon cannon retract the way it does in game due to the internal structure of the middle